Advanced-technology MirroFlex Structures Manuel d'utilisateur télécharger pdf

ATI-MFFII Revision 2 Effective Date: 8/5/12

Advanced Technology, Inc (800) 849-1320 www.advtechnology.com

Page 1 of 6

MirroFlex™ Structures

Fabrication and Installation Instructions

MirroFlex™ Structures are decorated thermoplastic sheets with high impact resistance and are

available in a wide variety of patterns and colors. They can be used as a value-added product in areas

that vertical grade High Pressure Laminates (HPL) are typically used.

General

Sizes - 4’ x 8’ x .032” (1220 x 2440 x .8 mm). MirroFlex Structures are also available as 2’ x 2’ and

2’ x 4’ Lay-in (grid) ceilings tiles; 2’ x 2’ and 2’ x 4’ Glue-up tiles; 18” x 24” Backsplash tiles; and 30”-

32” x 48” Wainscot tiles.

Most product ships with clear protective film or with TuffCote™.

Slight imperfections and color variations from sheet to sheet are possible and considered normal.

Please inspect each sheet carefully before fabrication to insure it meets your needs.

Storing

Store flat and acclimatize in the same environment for at least 24 hours before fabrication.

Cutting/Fabricating

MirroFlex™ Structures can easily be cut to size with razor knife and scissors or with routers, saw

blades, and drilling tools for thermoplastics. When fabricating MirroFlex always cut from the

decorated side.

Lamination

Like HPL, Structures sheets can be bonded with contact cement, but you must use a product

compatible with PVC.

Cleaning and Care

Clean only with warm soapy water. Never use abrasive cleaners.

Molding

Molding is available to join and finish Structures sheets. Inside corners, outside corners, edge trim

and universal trim strips are shown below.

Trims available in 4’ or 8’ lengths.

1 2 3 4 5 6